Lucent Technologies SLC ConnectReach User & Service Manual page 241

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the RS-232 Interface
(Continued)
Procedure
(continued)
™
System
If you set the baud rate to a speed the modem or attached computer cannot
match, use one of these methods to correct the problem:
If an Ethernet or Network T1/DSX-1 address is configured and the SLC
3
ConnectReach system is connected to the LAN or WAN, you can connect
using Telnet or a Web browser and reset the baud rate to the correct speed
for the modem or computer.
If no Ethernet or Network T1/DSX-1 address is configured, you cannot
3
connect to the SLC ConnectReach system over the network. Contact the
Lucent Technologies NetCare Knowledge Center (NKC) at
1-866-LUCENT8 for assistance.
Issue 4 June 2002 4-155
363-208-050