Lucent Technologies SLC ConnectReach User & Service Manual page 428

Software Upgrade, Maintenance, and Trouble Clearing
Maintenance Procedures
Using the Archive Command to Upload/
Download Configuration Settings
(Continued)
Uploading the
current
configuration over
the network to an
FTP server
9-14 Issue 4 June 2002
Use the following procedure to upload and store the current configuration settings
on an FTP server:
Step Procedure
1 At the Main prompt, enter the archive command:
> archive
2 At the Archive prompt, enter the net-upload command:
(archive)>
net-upload
3 At the Archive:Net-upload prompt, enter the commands shown in the
following table.
Enter this
command...
server-ipaddr
filename
user
password
4 To save the settings, enter the save command.
(archive)> save
5 To start the upload, enter the do-upload command:
(archive)>
do-upload
Stop! End of Procedure.
...and specify this
value Comments
Host name or IP address of the
FTP server to which the
name, ip-addr
configuration is to be uploaded.
Path and file name of the file to be
saved on the FTP server. The file
pathname
should have a .txt suffix.
Username valid on the FTP server.
username
Password for the username.
password
363-208-050
(Continued on next page)