Lucent Technologies SLC ConnectReach User & Service Manual page 193

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Passwords (Continued)
Access submenu
(continued)
Change an existing
password
Deleting a password
Logging in to the
SLC ConnectReach
system
™
System
The features-show command in the Access submenu would display the
following:
User Menu Group Feature Access
------------------------------
Default Data
User Menu Custom Feature Access
-------------------------------
1: DENY: config:Synchronous-interface
2: PERMIT: warm-start
To change the password for an existing login name, follow the same procedure as
for adding a new login name. However, in Step 3, enter the new password.
To delete a password for an existing login name, enter the password command
without a login name. For example:
(config:password)> carrier
After you configure login names and passwords, the next time you access the
SLC ConnectReach system you must enter a name and password. After you
enter the user name and password, the Main Menu prompt appears. For example:
Please enter name:
fred
Enter password:
******
>
(Continued on next page)
Issue 4 June 2002 4-107
363-208-050