Lucent Technologies SLC ConnectReach User & Service Manual page 152

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Digital Trunks (Continued)
Procedure
(continued)
4-66 Issue 4 June 2002
™
System
Step Procedure
4 Make the necessary configuration changes. The following table describes these
commands.
To
Set the first channel
Set the last channel
Specify the trunk group
Enter the trunk signaling
type
Enter the signaling type
for incoming E&M trunks
Enter the signaling type
for outgoing E&M trunks
Specify the direction
Select the routing option
for incoming calls
Select the line routing
option
Select the digit-addressing
option
Specify how call is
handled if line is busy
Select the line to forward
the call if line is busy
Adjust transmit gain
Adjust receive gain
Load a configuration of a
channel
Write your changes to the
specified channels
Display all DS0s
Access online assistance Help
Enter this
command... ...and one of these options
begin [1]...24
end 1...[24]
group [1]...10
E&M, loop-start,
ground-start,
signaling [Unconfigure]
E&M-type- [wnk-start], imm-s,
incoming dly-d, wnk-d
E&M-type- [wnk-start], imm-s,
outgoing dly-d
direction in, out, [two-way]
incoming- DID-DNIS, ANI-DNIS,
routing [Group], Line
[1], line or line group
line-group #
digits-type [DTMF], MF, Pulse
[busy-sig], busy-out,
busy-treatment forward
busy-fwd-line 1...[24]
tx-gain-db 0, [-3], –6
rx-gain-db 0, [-3], -6, -12
load-template 1...24
copy-to-
channel-data
Show-all
363-208-050
(Continued on next page)