Lucent Technologies SLC ConnectReach User & Service Manual page 158

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Analog Trunks (Continued)
Procedure
(continued)
4-72 Issue 4 June 2002
™
System
Step Procedure
3 Make the necessary configuration changes (see the following table) or use the
load-template command to load an existing configuration of a channel.
To
Set the first channel
Set the last channel
Specify the trunk group
Enter the trunk signaling
type
Specify the direction
Select the routing option
for incoming calls
Select the line routing
option
Select the digit-
addressing option
Specify how call is
handled if line is busy
Select the line to forward
the call if line is busy
Adjust transmit gain
Adjust receive gain
Load a configuration of a
channel
Write your changes to the
specified channels
Display switched
channels
Access online assistance Help
Enter this command... ...and one of these options
begin [1]...24
end 1...[24]
group 1[2]...10
loop-start, grnd-
signaling start, [Unconfigure]
direction in, out, [two-way]
incoming-routing [Group], Line
[1], line or line
line-group group #
digits-type [DTMF], PULSE
[busy-sig], busy-out,
busy-treatment forward
busy-fwd-line 1...[24]
tx-gain-db 0, [-3], -6
rx-gain-db 0, [-3], -6, –12
load-template 1...24
copy-to-channel-
data
Show-all
363-208-050
(Continued on next page)