Configuring The Network T1/Dsx-1 Interface - Lucent Technologies SLC ConnectReach User & Service Manual

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Network T1/DSX-1
Interface (Continued)
Procedure
4-24 Issue 4 June 2002
™
System
After you have determined the carrier's configuration, follow these steps to
configure the network T1/DSX-1 interface:
Step Procedure
1 At the Config prompt, enter the network-t1 command:
(config)> network-t1
The prompt changes to the Config:Network T1 prompt.
(config:Network-t1)>
2 At the Config:Network T1 prompt, enter the appropriate commands from the
following table. The default setting for each command appears in brackets.
363-208-050
(Continued on next page)