Lucent Technologies SLC ConnectReach User & Service Manual page 189

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Passwords (Continued)
Introduction
(continued)
Add a login and
password
™
System
Passwords are stored using one-way encryption. If a customer loses or forgets
the user password, you must log in with Carrier privilege and set the user
password. However, if you lose or forget the carrier password, you must contact
Lucent Technologies, Inc. at
Add a login name and password using the following procedure:
Step Procedure
1 At the Config prompt, enter the password command:
(config)> password
The prompt changes to the Config:Password prompt.
(config:Password)>
2 At the Config:Password prompt, enter the privilege and the corresponding login
name, as shown in the following table. Login names can range from 3 to 16
characters in length.
To
Add a login name with
USER access privilege
Add a login name with
CARRIER access privilege carrier
Configure user access
Access online assistance
3 The utility then prompts you to enter a password for the login name. Passwords
can range from 3 to 16 characters in length. After you enter the password, the
utility prompts you to confirm the password by entering it again.
To configure access to additional commands for User privilege, enter the Access
4
command.
(config:Password)> Access
The prompt changes to the config:Password:Access prompt.
(config:Password:Access)>
5 Make the necessary configuration changes using the commands described in the
following section.
Stop! End of Procedure.
for assistance.
1-866-LUCENT8
Enter this command:
user
Access
Help
...and specify the value
name
name
(Continued on next page)
Issue 4 June 2002 4-103
363-208-050