Lucent Technologies SLC ConnectReach User & Service Manual page 499

EZ Config
Using EZConfig
Initial Configuration of the SLC
ConnectReach System (Continued)
Procedure
(continued)
Action/Prompt/Response
6. Select the trunk
processing alarm
state required by
the NOC. Select
idle to place the
trunks in an idle
state if there is a
problem. Select
busy to "busy out"
the trunks if a
problem occurs.
Click on the Next
button.
7. Select the trunk to
line signaling
conversion used
and click on the
Next button.
Screen Display
363-208-050
(Continued on next page)
Issue 4 June 2002 E-7