Lucent Technologies SLC ConnectReach User & Service Manual page 203

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Using ARP
Procedure
™
System
Use the following procedure to map an IP address to a physical address.
Step Procedure
1 At the config prompt, enter the ARP command:
ARP
(config)>
The prompt changes to the config:ARP prompt.
(config:ARP)>
2 At the config:ARP prompt, enter the ARP command and parameters to
carry out the tasks listed in the following table.
To
Convert an IP address or
host server's address to a
physical address
Clear one or all ARP
mappings
Display the table of all ARP
mappings
Access online assistance
Enter mappings as shown in the following examples:
(config:ARP)> arp 192.168.0.1 00:60:49:00:02:87
(config:ARP)> arp www.vina-tech.com
02:01:53:00:42:12
To clear a specific mapping, use the Clear-ARP command as in the
following example:
(config:ARP)> clear-arp 192.168.0.1
Enter this
command: ...and specify the value
[IP-address | host]
Ethernet-address
{x:x:x:x:x:x}
arp
clear-arp [ALL | IP-address]
show-arp-table
Help
(Continued on next page)
Issue 4
363-208-050
June 2002 4-117