Lucent Technologies SLC ConnectReach User & Service Manual page 129

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Synchronous Interface
(Continued)
Configuring using
the PVC submenu
commands
(continued)
™
System
Step Procedure
At the Config:FrameRelay:PVC1 prompt, enter the appropriate commands from
2
the following table. The default setting for each command appears in brackets.
Enter this
command...
DLCI
IP-address
netmask
RIP
version-RIP
NAT
SLA
Help
The Enet value assigns the primary Ethernet IP address (IP unnumbered).
*
Stop! End of Procedure.
SLA Configuration
A service level agreement (SLA) is a contract between a carrier and a customer
that specifies a measurable level of service the carrier will provide. SLAs offer a
way to document the success or a network to meet the needs and expectations of
the user.
...and specify this value Comments
[16]...991
IP-address, Enet*,
[Disable]
netmask
Enable, RxOnly,
TxOnly, [Disable]
[1], 2
PASS, IN, [OUT]
Enter the assigned DLCI for the
SLC ConnectReach system.
Enter the IP address for the frame
relay's interface, Enet or disable
this command.
Enter a netmask value, such as
255.255.255.0.
Select the mode of RIP to use.
Select the version of RIP to use.
Select the NAT option to use
Configure SLA
Access online assistance.
(Continued on next page)
Issue 4 June 2002
363-208-050
4-43