Lucent Technologies SLC ConnectReach User & Service Manual page 186

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Voice Mail (Continued)
Procedure
(continued)
4-100 Issue 4 June 2002
™
System
Step Procedure
2 Make the necessary configuration changes. The following table describes these
commands.
To
Enable the voice mail
system
Specify the line group for
the voice mail system
Specify the delay between
signaling the voice mail
system and sending a string integration-delay
Enable the stutter dial tone
as message waiting
indicator
Enable the two short rings
as message waiting
indicator
Specify the extension for
the voice mail system
Specify a name for the voice
mail settings
Specify the DTMF digit
prefix for the extension
Specify the DTMF string for
ringing and no answer
Specify the DTMF string for
busy
Specify the DTMF string for
unknown destination
Specify the DTMF string for
message waiting
Specify the DTMF string for
no message waiting
Load a preset profile
Access online assistance
Enter this command... ...and specify the value
enable [off], on
line-group (1...[10])
[500] (0...5000)
(ms)
stutter-tone [off], on
periodic-ring [off], on
dial-number (DTMF digits)
profile-name (name)
direct-prefix [*](DTMF digits)
[#d] (DTMF
ring-no-answer digits,'s','d')
[#d] (DTMF
busy-no-answer digits,'s','d')
[#d] (DTMF
forward-all digits,'s','d')
mwi-on-prefix (DTMF digits)
mwi-off-prefix (DTMF digits)
load-profile
Help
(Continued on next page)
363-208-050