Lucent Technologies SLC ConnectReach User & Service Manual page 208

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring NAT and PAT (Continued)
Procedure
(continued)
4-122 Issue 4 June 2002
™
System
Step Procedure
2 At the Config:Nat prompt, enter the appropriate commands and options to
configure NAT from the following table.
Enter this
command...
enable
Dynamic
Static
PassThru
Show-sessions
Clear-sessions
Help
...and specify this
value Comments
Enables NAT.
[off], on
The submenu for dynamic allocation of
IP addressing between LAN and WAN.
The submenu for static allocation of IP
addressing between LAN and WAN.
To configure pass thru LAN addresses
that are valid Internet IP addresses;
requires secondary IP address 9see
Configuring the Ethernet Interface on
page 4-49).
Shows sessions associated with
[all], udp, tcp,
icmp, config specified parameter.
Clear sessions associated with
[all], udp, tcp,
icmp specified parameter.
Access online assistance
363-208-050
(Continued on next page)