Lucent Technologies SLC ConnectReach User & Service Manual page 250

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Setting All Configuration Settings to
Default
Introduction
Procedure
Preserving default
settings
4-164 Issue 4 June 2002
™
System
Every configuration command has a default setting. The default setting for each
command is displayed on screen in brackets after you type the question mark key
( ? ) at the Config prompt or one of the Config submenu prompts.
NOTE:
The default command erases all configuration data.
To set all configuration settings to their default value, enter the default
command at the Config prompt.
(config)> default
The preserve-default command erases all configuration data except
Ethernet, password, and RS-232. To set the selected configuration settings to
their preserve default value, enter the preserve-default command at the
Config prompt.
(config)> preserve-default
NOTE:
If you change any of these commands, you must save the configuration and
reboot the SLC ConnectReach system using the warm-start command
for the new settings to take effect.
363-208-050