Lucent Technologies SLC ConnectReach User & Service Manual page 443

Software Upgrade, Maintenance, and Trouble Clearing
Trouble Clearing Procedures
Preparing the SLC ConnectReach System
for Channel Testing (Continued)
Entering the
diagnose command
(continued)
Definition of
diagnose command
options
Step Procedure
4 Using the external test equipment, verify that the channel is in the
specified state.
5 When you have completed testing, set the channel back to normal state
using the normal command.
6 Enter the exit command to return to the Main Menu.
Stop! End of Procedure.
The diagnose command options are described as follows:
Normal
Idle
Busy
Ringing
In normal mode, signaling passes through from the T1
line to the phone, and the channel is able to process
calls normally. All the remaining modes interrupt the
T1 signaling and force a state other than normal.
When set to idle mode, a connected phone should
detect tip open on the channel (for example, a dial
tone). If it does, the line should be able to receive calls
when reset to normal mode.
When set to busy, a connected phone should detect
tip closed on the channel (for example, a busy signal).
If it does, the line should be able to receive calls when
reset to normal mode.
When set to ringing mode, a connected phone should
ring for 2 seconds on and 4 seconds off. If it does, the
line should be able to receive calls when reset to
normal mode.
363-208-050
(Continued on next page)
Issue 4 June 2002 9-29