Lucent Technologies SLC ConnectReach User & Service Manual page 117

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Secondary/Fractional
T1/DSX-1 Interface (Continued)
Procedure
(continued)
™
System
Step Procedure
3 When you have made the necessary configuration changes, you can
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT).
NOTE: If you change any of these commands, you must save the
configuration and reboot the SLC ConnectReach system using the
warm-start command for the new settings to take effect.
Stop! End of Procedure.
363-208-050
Issue 4 June 2002 4-31