Lucent Technologies SLC ConnectReach User & Service Manual page 275

Installation
®
Mount the SLC ConnectReach
Rack Mount (Continued)
Mount the SLC
ConnectReach
system in a
19-inch rack
(continued)
Mount the SLC
ConnectReach
system in a 23-inch
rack
™
System
Rear mount
Install the brackets as shown to rear mount the SLC ConnectReach System in a
19-inch rack.
NOTE:
The mounting brackets supplied with the SLC ConnectReach system are
for mounting the unit in an American national standards institute (ANSI)
type relay rack. The mounting brackets required to mount the unit in a
Bellcore relay rack must be ordered separately. Refer to document
363-208-000, SLC-2000 Access System, Applications, Planning, and
Ordering Guide, for ordering information.
To mount the SLC ConnectReach system in a 23-inch rack, attach the short side
of the brackets to the SLC ConnectReach system. You can arrange the brackets
for a front, midway, or rear mount (the connectors are located on the front of the
unit).
NOTE:
Attach the short side of the brackets to the SLC ConnectReach system.
Front mount
Install the brackets as shown to front mount the SLC ConnectReach System in a
23-inch rack.
363-208-050
(Continued on next page)
Issue 4 June 2002 5-23