IP Address Translation for Enterprise
NAT (Continued)
Procedure
-XQH
F-4
Issue 4
The translation procedure is as follows.
Step
Procedure
1
At the config prompt, enter the NAT command:
(config)> NAT
The prompt changes to the config:NAT prompt.
( config:NAT )>
2
At the config:NAT prompt, enter the enable on command, and then
Dynamic command.
Typically, you will want to establish dynamic allocation so you can
translate many connections to one connection, thereby reducing
the number of WAN IP addresses used and providing security.
The prompt changes to the config:NAT prompt.
(config:NAT:Dynamic)>
3
At the config:NAT:Dynamic prompt, enter the group to be configured. For
example:
(config:NAT:Dynamic)> 1
The prompt changes to the submenu-group that is to be
configured. For example:
(config:NAT:Dynamic:Group1)>
363-211-129
Appendix E
(Continued on next page)