Lucent Technologies SLC ConnectReach User & Service Manual page 482

Custom Firewall Configurations
Configuring IP Filter Groups
Configuring IP Filter Group (Continued)
Examples of using
IP filter groups
C-6 Issue 4 June 2002
The following examples describe how to use IP filter groups.
Example 1
Allow only pings packets to get through from WAN.
Enter a question mark after the Inbound Filter command to view the settings.
>(Config:IPFirewall:INFilterGroup) ?
IP Inbound Filter settings for Example 1 are as follows:
Filter1 permit ping
defaultAction denyAll
Example 2
Do not allow any HTTP (www) sessions requests coming from WAN side (except
for already established ones).
Enter a question mark after the Inbound Filter command to view the settings.
>(Config:IPFirewall:INFilterGroup) ?
IP Inbound Filter settings for Example 2 are as follows:
Filter1 permit http est
Filter2 deny http
defaultAction permitAll
363-208-050