Installation
®
Mount the SLC
ConnectReach
Wall Mount
Introduction
Wall mount using
stationary mounting
brackets
™
System
The SLC ConnectReach system can be mounted on a wall using either of the
following two methods described in this section:
Stationary mounting using the mounting brackets supplied with the unit
3
Attaching the unit(s) to a hinged wall mount assembly that is fastened to
3
the wall. Up to four units can be attached to the hinged wall mount
assembly. After the first unit is mounted on the assembly, extension
brackets are used to mount the additional units. The hinged wall mount
assembly is not supplied with the SLC ConnectReach system and must be
ordered separately.
Use the following procedure to mount the SLC ConnectReach system on a wall
using the stationary mounting brackets.
363-208-050
(Continued on next page)
Issue 4
June 2002
5-25