Lucent Technologies SLC ConnectReach User & Service Manual page 162

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Lines (Continued)
Key commands
(continued)
4-76 Issue 4 June 2002
™
System
Polarity-reversal
Trunk-ring-default Trunk-ring-default applies to E&M and line-to-line
Paging-line
Hunting
The copy-to-channel-data command only modifies LCR/DID channels. If the
begin and end commands include channels that are not switched, the copy-to-
channel-data warns the user that data for those channels was not modified.
NOTE:
There is no option for tone versus pulse dialing. The software can always
detect both dial pulses and DTMF address digits.
This command is used for reversing the polarity of the
DC when the central office has answered. Some PBXs
use this for billing purposes.
calls. Ring cadence, for loop- or ground-start trunks, is
controlled by the CO. This command sets the number
of rings for outside trunk calls. If set to single, outside
trunk calls get a single ring and inside calls get a
double ring. If set to double, the opposite is true. This
command is system wide and requires the optional
BOX feature. The distinctive-ring command in
the BOX submenu must be turned on for this
command to function properly.
This command is used to designate a line for paging
output.
This command sets the type of line group hunting
used for incoming calls. If set to most idle, the next line
chosen to receive the call will be the one that was
least used. If set to linear, the lowest line number that
is not busy will receive the call. This command is
system wide and requires the optional BOX feature.
The distinctive-ring command in the BOX
submenu must be turned on for this command to
function properly.
363-208-050
(Continued on next page)