®
Configuring the SLC
ConnectReach
Using the Configuration Commands
Configuring the Channel Bank Mode
Introduction
4-52
Issue 4
June 2002
™
System
The SLC ConnectReach system acts as a channel bank in which there is a
one-to-one association between T1 voice DS0s (digital trunks) and analog (FXS)
ports.
The following figure shows channel bank functionality. The telephone symbol
represents users of the system. The SLC ConnectReach system maps digital
trunks to FXS or DID lines.
Before configuring the channel bank menu, you must know how the digital trunks
are configured in the central office, and how the equipment connected to the
analog ports (analog phones, PBX or key system) is configured.
The user interface allows you to set up a configuration template which contains
commands that are applied to a range of channels. The channel bank template
contains the following commands:
Signaling
3
Incoming-type
3
Outgoing-type
3
Analog-interface
3
Far-end-disconnect
3
Loop-reversal
3
Tx-gain-db
3
363-208-050
(Continued on next page)