Lucent Technologies SLC ConnectReach User & Service Manual page 229

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring QOS (Continued)
Example 1
(continued)
™
System
To configure the example shown in the figure, proceed as follows:
Step Procedure
1 At the Config prompt, enter the QOS command:
(config)> QOS
The prompt changes to the Config:QOS prompt.
(config:QOS)>
2 At the config:QOS prompt, enter the following commands:
(config:QOS)> enable on
(config:QOS)> qos add src 207.242.96.145 255.255.255.255
(config:QOS)> reserved-bandwidth 128
3 To view the QOS settings, enter the show-qos-table command.
(config:QOS)> show-qos-table
IP QOS Table
--------------------------------------
Src Addr
207.242.96.145
4 When you have made the necessary configuration changes, you can
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT).
NOTE: The new command value takes effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new value.
Stop! End of Procedure.
Dst Addr
Src Mask
255.255.255.0
Dst Mask
(Continued on next page)
Issue 4 June 2002 4-143
363-208-050