Lucent Technologies SLC ConnectReach User & Service Manual page 280

Installation
®
Mount the SLC ConnectReach
Wall Mounting (Continued)
Wall mount using
hinged wall mount
assembly
(continued)
5-28 Issue 4 June 2002
™
System
Step Procedure
2 Secure the hinge assembly plate to the plywood surface using #14,
¾-inch pan-head Phillips screws in each of the six large mounting holes.
3 Position a SLC ConnectReach system unit on its side with the VOICE
CHANNELS connector at the top. Insert the unit between the upper and
lower mounting flanges with the rear of the unit facing the hinge on the
wall mount assembly. Attach the unit to the upper and lower flanges using
the 18 #6-32 mounting screws and washers provided. There are nine
screw locations on the top and nine on the bottom of the assembly (refer
to the following figure showing a top view of the mounting assembly).
4 If only a single SLC ConnectReach system unit is to be installed at this
time, then secure the mounted unit against the wall using the two captive
screws that screw into the existing holes on the top and bottom edges of
the hinged assembly plate. Otherwise, continue with Step 5.
363-208-050
(Continued on next page)