Lucent Technologies SLC ConnectReach User & Service Manual page 317

®
Provisioning the SLC -2000 RT/HDT
DT Server Preparation, Installation, and Provisioning
Option and Install DT Server in MDS
(Continued)
Install DT Server
It is suggested that the DT Server card be installed in the MDS after the SLC
ConnectReach system has been configured and installed at the customer site to
avoid unnecessary alarms at the CO and RT.
Use the following procedure to install the DT Server card:
Step Procedure
1 Verify that the option switches on the DT Server card are set correctly
(refer to the previous procedure).
2 Verify that the SLC ConnectReach system has been configured and
turned up.
3 Install the DT Server in the appropriate channel unit slot in the
appropriate MDS.
Response: All alarms clear within 3 minutes.
4 Press the UIP LED Test button and verify that all DT Server card light
emitting diodes (LEDs) light. If all LEDs do not light, replace the DT
Server and repeat this procedure from Step 1.
Stop! End of Procedure.
363-208-050
Issue 4 June 2002 6-9