Examples Of The Different Methods Of Configuring The; Slc Connectreach ™ System; Quickstart Configuration Example - Lucent Technologies SLC ConnectReach User & Service Manual

Configuration Examples

Examples of the Different Methods of Configuring the

® ™
SLC ConnectReach System
Examples of the Different Methods of
Configuring the SLC
™
ConnectReach

Quickstart Configuration Example

Configuration site
conditions
Configuration list
®
System
This configuration applies to sites that:
Use private Internet protocol (IP) network addresses.
3
Have a telephone system and T1 link to the central office (CO) for which
3
®
the SLC ConnectReach
"Configuring the SLC
for all parameters.
If these conditions are met, you only need to configure the following:
Synchronous interface encapsulation scheme and addresses [including
3
data link connection identifier (DLCI), if encapsulation is set to frame relay]
Site domain name
3
Default route
3
Voice and data channel assignments
3
Login names and passwords.
3
™
system defaults are appropriate. Chapter 4,
® ™
ConnectReach System", describes the defaults
363-208-050
(Continued on next page)
B-3
Issue 4 June 2002