Lucent Technologies SLC ConnectReach User & Service Manual page 95

®
Configuring the SLC ConnectReach
®
Preparing the SLC ConnectReach
Configuration
Making Connections to the SLC
ConnectReach System (Continued)
Make the following connections when using a local computer to configure the SLC
Connection at the
ConnectReach system:
10Base-T (Ethernet)
port
™
System
™
System for Initial
Step Procedure
1 If connecting the computer to the 10BASE-T (Ethernet) connector on the
ConnectReach system by means of an Ethernet hub, continue with Step
2. Otherwise, proceed to Step 4.
2 Connect one end of a 10BASE-T Ethernet cable to the network interface
card on the computer and the other end to the appropriate port on the
Ethernet hub.
3 Connect a second 10BASE-T Ethernet cable between the Ethernet hub
and the 10BASE-T connector on the ConnectReach system. Proceed to
Step 6.
4 Connect one end of a crossover cable to the 10Base-T (Ethernet)
connector on the SLC ConnectReach system, shown in the following
figure.
5 Connect the other end of the crossover cable to a network interface card
on the computer.
6 Set the Internet protocol (IP) address and netmask for transport control
protocol/Internet protocol (TCP/IP) of the network interface card using
the following example:
IP address:
Netmask:
Stop! End of Procedure.
192.168.0.2 (or another address on the same
network, 192.168.0.2 — 192.168.0.255)
255.255.255.0
(Continued on next page)
Issue 4
363-208-050
4-9
June 2002