Lucent Technologies SLC ConnectReach User & Service Manual page 180

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Dialing (Continued)
Key commands
(continued)
4-94 Issue 4 June 2002
™
System
Default-output
Trunk-access
DID-received-
digits
DID-undefined-
type
DID-undefined-
line-num
Pause
Test
Extension-prefix
The show-all command displays the contents of both the detect-table and the
output-table.
This command specifies the row in the output table
entry that contains both the primary and alternate
trunk groups.
This command determines how a caller will access an
outside trunk. If trunk-access is set to access code,
the caller dials the access-code to get an outside
trunk. If trunk-access is set to auto, the caller dials the
access-code in combination with the extension to get
an inside line.
This command specifies the number of direct inward
dial (DID) digits to expect from the CO. The number of
DID digits must be the same as the number specified
in the extension-digits command in the
configuring extensions section described earlier in this
chapter.
This parameter specifies the treatment of calls with
unknown DID-strings that are received from the CO.
There are two options: route the call to the specified
analog line or refuse the call (reorder).
If the CO sends an invalid DID string, the call will be
forwarded to this line.
This command specifies the pause interval (expressed
in milliseconds) inserted for a P in the digits option of
the dial-string command.
This command prompts the operator to enter a digit
string and view the selected trunk group as well as the
output digits. This command verifies that the dial-table
is functioning correctly.
This command allows the dialed digits to be passed on
to the class 5 switch, and should only be used when
the SLC ConnectReach system is connected to a
switch that is configured for such digit passing. This
command displays the contents of both of the detect-
table and the output-table.
363-208-050
(Continued on next page)