Lucent Technologies SLC ConnectReach User & Service Manual page 381

SLC ConnectReach System Monitoring
Using the Statistics Command to Display System
Elements Status
Displaying Statistics for Route
(Continued)
Entering the route
command
(continued)
This is a status report only; no errors are reported. The Ref column indicates the
number of interfaces associated with each route. Only routes that are up are
displayed. The routing table is updated once every 30 seconds. A description of
the possible routing states follows:
Good
Suspect
Bad
A direct, static, or default route is good if the
associated interface is up. A routing information
protocol (RIP) route has a good state if it has been
heard from in the last 60 seconds.
This state applies to RIP routes only. A RIP route is
suspect if it has not been heard from in the last 60
seconds.
This state applies to RIP and static routes only. A route
in a bad state is about to be deleted. It is kept on the
routing table for 3 minutes during which routing
neighbors are notified of its state. It takes 94 seconds
for a RIP route to go from suspect to bad.
363-208-050
7-47
Issue 4 June 2002