Lucent Technologies SLC ConnectReach User & Service Manual page 365

SLC ConnectReach System Monitoring
Using the Statistics Command to Display System
Elements Status
Displaying Statistics for Voice Channels
(Continued)
Entering the voice-
states command
(continued)
The following table lists the possible channel states that may appear in the State
column of the voice channel statistics report.
State Description
A call is currently active on the channel.
active
The channel is currently idle (no call is active).
idle
The channel is in ringing mode either by means of the Diagnose
command, discussed later in this chapter, or because an incoming
ringing
connection is being requested on the channel.
The channel has been put in tone1k mode either by the Diagnose
command, discussed later in this chapter, or by the carrier. In this mode, a
tone1k
phone attached to the channel will emit an audible 1-kHz tone.
The channel has been put in reversal mode either by the Diagnose
command, discussed later in this chapter, or by means of carrier
reversal
signaling.
Hardware to support the channel is present in the SLC ConnectReach
system, but the channel has not been enabled (refer to 4, "Configuring
®
not active the SLC ConnectReach
™
System.").
Issue 4
363-208-050
7-31
June 2002