Lucent Technologies SLC ConnectReach User & Service Manual page 316

®
Provisioning the SLC -2000 RT/HDT
DT Server Preparation, Installation, and Provisioning
Option and Install DT Server in MDS
(Continued)
DT Server optioning
procedure
(continued)
6-8 Issue 4 June 2002
Step Procedure
1 On the DT Server printed circuit board, set the OU/DSX switch toward
DSX.
2 Set the B/Z switch toward B.
3 Set the DSX equalization TRANS-0,1,2 option switches as required (refer
to the following table).
Equalization Switch (TRANS)
2 1
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
Note:
These distances are for ABAM cable used in the central office (CO).
Refer to 915-710-115 for calculations for other types of cable used
for collocated remote terminal (RT) and T1 extension applications.
Stop! End of Procedure.
Distance to DSX-1
(Note)
0 (in Feet)
ON 0 to 132
OFF 133 to 265
ON 266 to 398
OFF 399 to 532
ON 533 to 655
(Continued on next page)
363-208-050