Lucent Technologies SLC ConnectReach User & Service Manual page 212

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring NAT and PAT (Continued)
Procedure
(continued)
4-126 Issue 4 June 2002
™
System
Step Procedure
5
Pass-Thru
1. At the specific submenu, enter the group to be configured.
For example :
(config:NAT:PassThru) > 1
2. The prompt changes to the submenu-group that is to be
configured. For example:
(config:NAT:PassThru:Group1) >
At the submenu-group prompt, enter the appropriate command from the
following Pass-Thru configuration commands table.
Enter this ...and specify
command... this value
enable [off], on
IN-Start 0.0.0.0
IN-End 0.0.0.0
Help
.Make sure you have configured a secondary IP address for the Ethernet
Interface before enabling Pass-Thru definition (see Configuring the
Ethernet Interface on page 4-49 for details).
6 When you have made the necessary configuration changes, enter the
exit command or an exclamation point (!) (quoted as "\ |" through the
SLC-2000 Access System CIT) to return to the NAT menu.
NOTE:
The new command values take effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new values.
Stop! End of Procedure.
Comments
Enables pass-thru definition.
Enter the starting IP addresses for the range.
Enter the ending IP addresses for the range.
Access online assistance
363-208-050