Lucent Technologies SLC ConnectReach User & Service Manual page 511


$SSHQGL[ (
IP Address Translation for Enterprise
NAT (Continued)
Procedure
(continued)
Step Procedure
4 At the submenu-group prompt enter the enable on command, then the
Start and End commands for the in range and the out range. See the
table below; the IP addresses refer to the commands used in the ENAT
example (shown in the figure below) to create Group1.
About in and out ranges. The in range is the LAN side of the Corporate
Headquarter network. The out range is the WAN side of the Corporate
Headquarter's router module.
Enter this
command...
enable
in-Start
in-End
out-Start
out-End
Three Different FR PVCs configured for Enterprise NAT
...and specify this
value Comments
Enables dynamic allocation.
[off] | on
Enter the starting LAN or WAN IP
192.168.0.1
address for the range.
(for example)
Enter the ending LAN or WAN IP
192.168.0.254
address for the range.
(for example)
Enter the starting WAN IP address
213.213.213.1
for the range.
(for example)
Enter the ending WAN IP address
213.213.213.1
for the range.
(for example)
(Continued on next page)
-XQH 
F-5
Issue 4