Lucent Technologies SLC ConnectReach User & Service Manual page 54

Product Description
Physical and Functional Description
Description of Interface Ports
(Continued)
NETWORK T1/
DSX-1 line
MONITOR port
SECONDARY/
FRACTIONAL T1/
DSX-1 LINE port
2-12 Issue 4 June 2002
The NETWORK T1 line MONITOR port accepts standard bantam miniature
telephone plugs from test equipment used to monitor the network T1/DSX-1 line.
NOTE:
In the event that it becomes necessary to connect test equipment to the
NETWORK T1 line MONITOR connector, be sure the test equipment is
operating in the bridge mode. Otherwise, the test equipment can terminate
the T1 line, thereby reducing T1 receive signal strength to the SLC
ConnectReach system.
The SECONDARY/FRACTIONAL T1 LINE port contains an eight-pin, modular,
RJ-48C connector that accepts the secondary/fractional T1/DSX-1 line for the
SLC ConnectReach system. The secondary/fractional T1/DSX-1 line connects the
SLC ConnectReach system to a private branch exchange (PBX) or key system
that has a T1 interface. Open data devices, such as video codec, can also be
connected to the fractional T1 interface card by means of this port.
The connector pin assignments are the same as the pin assignments for the
NETWORK T1 LINE connector described previously.
363-208-050
(Continued on next page)