Lucent Technologies SLC ConnectReach User & Service Manual page 211

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring NAT and PAT (Continued)
Procedure
(continued)
™
System
Step Procedure
4
Static
1. At the specific submenu, enter the group to be configured.
For example :
(config:NAT:Static) > 1
The prompt changes to the submenu-group that is to be
configured. For example :
(config:NAT:Static:Group1) >
At the submenu-group prompt, enter the appropriate command from the
following Static configuration commands table.
Enter this
command...
enable
IN-Start
IN-End
OUT-Start
OUT-End
ALLOW-INBOUND off, [on]
Show
Clear
Help
...and specify
this value Comments
Enables static allocation.
[off], on
Enter the starting IP addresses for the range.
0.0.0.0
Enter the ending IP addresses for the range.
0.0.0.0
Enter the starting IP addresses for the range.
0.0.0.0
Enter the ending IP addresses for the range.
0.0.0.0
Allows inbound initiation from WAN.
Shows connections associated with specified
[all], udp, tcp,
icmp parameter for this static group.
Clear connections associated with specified
[all], udp, tcp,
icmp parameter for this static group.
Access online assistance
(Continued on next page)
Issue 4 June 2002 4-125
363-208-050