Lucent Technologies SLC ConnectReach User & Service Manual page 300

Installation
48-Line Master/Slave Configuration
Connecting Master and Slave Units
Procedure
5-48 Issue 4 June 2002
Connect and configure a master SLC ConnectReach system and a slave
ConnectReach system for daisy chaining using the following procedure. Refer to
the following figure when making connections.
Step Procedure
1 Mount the master SLC ConnectReach systems using the mounting
information located earlier in this chapter. Mount the ConnectReach
system according to instructions in the document ConnectReach Access
System, User/Service and Ordering Manual (363-214-001).
CAUTION:
Do not mount one system on top of the other system.
363-208-050
(Continued on next page)