Procedures - Lucent Technologies SLC ConnectReach User & Service Manual

Installation
Connect Cables to the SLC ConnectReach System

Procedures

Introduction
Connect the
Ethernet and T1
cables to the unit
Connect the unit to
the site phone
system
After mounting the SLC ConnectReach system, you are ready to connect the
cables to the unit.
Connect the Ethernet and network cables to the SLC ConnectReach system.
Step Procedure
1 Connect the Ethernet cable from the Ethernet network hub to the
10BASE-T connector on the SLC ConnectReach system. The SLC
ConnectReach system Ethernet port operates in half-duplex transmission
mode.
2 Connect a shielded T1 cable to the NETWORK T1 — LINE connector on
the SLC ConnectReach system.
NOTE:
For best performance at installation sites with 'noisy' grounds, a partially
shielded T1 cable should be connected between the SLC ConnectReach
system and the telephone network. Connect the shielded connector end of
the cable (typically with a white boot) to the NETWORK T1 — LINE
connector on the SLC ConnectReach system and connect the unshielded
connector end (typically with a black boot) to the telephone network
interface.
Connect the unit to the phone system of the site and analog trunk lines.
NOTE:
The secondary/fractional T1/DSX-1 cable is normally a crossover cable.
PBX or key system (with T1 interface)
Connect a shielded T1 cable from the private branch exchange (PBX) or key
system (with T1/DSX-1 interface) to the SECONDARY/FRACTIONAL T1 — LINE
connector located on the SLC ConnectReach system.
363-208-050
(Continued on next page)
Issue 4 June 2002 5-41