Lucent Technologies SLC ConnectReach User & Service Manual page 169

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Lines (Continued)
BOX features
description
(continued)
™
System
Call pickup group This feature allows for a call pickup group number to
Caller ID
To return the BOX-features back to their defaults, type line-group-default. To turn
fwd-num-variable, fwd-num-no-answer, and fwd-num-busy off, enter the
command without any numbers. To access online assistance, type help.
be assigned to each line. A call may be answered by a
different line in the same call pickup group by dialing a
feature code. If multiple lines in a call pickup group are
ringing, only one of them is answered on each pickup
attempt. If no line is ringing when the user dials the
feature code, a fast busy tone is heard.
There are three forms of caller identification (ID): line-
to-line or intercom, analog trunk call, and incoming
digital trunk call. Caller ID for line-to-line displays the
extension number. There is no configuration
necessary to display the extension number of a line-to-
line call. Caller ID with an incoming analog trunk call is
passed through to the called line. For an incoming
digital trunk call, the SLC ConnectReach system is
configured to accept automatic number identification
(ANI). The ANI is converted to analog caller ID
information for display on a display telephone. For
Caller ID to be displayed in both digital and analog
trunk calls, the CO must generate caller ID
information. For information concerning configuring
the digital trunk to receive automatic number
identification-dialed number identification service (ANI-
DNIS), refer to the section entitled "Configuring Digital
Trunks", located earlier in this chapter.
363-208-050
(Continued on next page)
Issue 4 June 2002 4-83