Lucent Technologies SLC ConnectReach User & Service Manual page 201

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Routes (Continued)
Procedure
(continued)
™
System
Step Procedure
2 At the Config:IPRoutes prompt, enter the default WAN command:
(config:IPRoutes)> default WAN
3 At the Config:IPRoutes prompt, enter the Route Add command:
(config:IPRoutes)> route add 213.213.213.0
255.255.255.0 PVC2
(config:IPRoutes)> route add 213.213.214.0
255.255.255.0 PVC2
(config:IPRoutes)> route add 201.100.100.0
255.255.255.0 GW 207.104.144.1
4 When you have made the necessary configuration changes, you can
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT)
NOTE: If you change any of these commands, you must save the
configuration and reboot the ConnectReach Terminal using the warm-
start command for the new settings to take effect.
Stop! End of Procedure.
.
Issue 4 June 2002 4-115
363-208-050