Lucent Technologies SLC ConnectReach User & Service Manual page 153

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Digital Trunks (Continued)
Procedure
(continued)
™
System
Step Procedure
5 Use the copy-to-channel-data command to write your changes to
the specified trunks.
6 Use the Show-all command to see the actual channel configuration.
7 Type exit or an exclamation point (!) (quoted as "\ |" through the SLC-
2000 Access System CIT) to return to the Config menu.
NOTE:
The new command values take effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new values.
Stop! End of Procedure.
363-208-050
Issue 4 June 2002 4-67