Lucent Technologies SLC ConnectReach User & Service Manual page 104

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Basic Procedure For Using the
Configuration Commands (Continued)
Introduction (continued)
4-18 Issue 4 June 2002
™
System
To...
Configure the RS-232 port
Configure syslog monitoring facility
Configure log on for file transfer protocol (FTP) download
Display features
Set features
Allows creation of configuration settings for remote SLC
ConnectReach system
Show all configuration settings
Save the configuration settings in the SLC ConnectReach
system
Set all configuration commands to their default values
Set all configuration commands to their default values, retaining
the Ethernet, password, and RS232 commands
Access online assistance
Exit the Config prompt and return to the Main Menu prompt
Every configuration command has default settings, including IP addresses. The
default settings for each configuration command are displayed on screen in
brackets after you enter a question mark ( ? ) at the Config prompt.
363-208-050
Enter this command...
RS232
syslog
Ftp-log-dump
features-show
set-features
template-archive
show
save
default
preserve-default
Help
exit
(Continued on next page)