Lucent Technologies SLC ConnectReach User & Service Manual page 176

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Dialing (Continued)
Introduction
(continued)
4-90 Issue 4 June 2002
™
System
There are two configuration tables that are used to describe this process: the
detect table and the output table. The following figure shows the operation of
these tables.
In this figure, the telephone number 411 is detected by detect-table, row 1, which
refers to the output-table, row 3. This entry in the output-table directs the software
to seize a trunk from trunk group 7, then delete 411, and dial 1-415-555-1212.
Also in this figure, any seven-digit number is detected by detect-table, row 2,
which specifies that trunk group 3 be used for the call, which is to have the digits
1415 inserted.
The Dialing command is included in the LCR/DID telephone functionality mode
and the Dialing menu will appear only when the LCR/DID optional feature is
installed in the SLC ConnectReach system. In the LCR/DID mode, additional
configuration menus, including the Dialing menu, are used to specify call routing
and DID operation.
NOTE:
The channel-bank menu must be used in conjunction with the Dialing
menu.
363-208-050
(Continued on next page)