Lucent Technologies SLC ConnectReach User & Service Manual page 246

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Displaying Current Configuration
Settings
Procedure
4-160 Issue 4 June 2002
™
System
To show the current configuration settings, enter the features-show command
at the Config prompt.
(config)> features-show
The SLC ConnectReach system Utility lists all current configuration settings. The
following figure shows an example of part of the configuration settings list.
...
SNMP
enable on
SNMP-host 199.199.199.3
cold-start on
warm-start on
link-down on
link-up on
login-failures on
!
NAT
enable on
!
DNS
enable on
primary-dns-server 199.199.199.4
secondary-dns-server 199.199.199.5
!
RS232
baud-rate 9600
!
...
363-208-050