Displaying Statistics For A T1 Interface - Lucent Technologies SLC ConnectReach User & Service Manual

SLC ConnectReach System Monitoring
Using the Statistics Command to Display System
Elements Status

Displaying Statistics for a T1 Interface

Entering the T1
command
7-22
Issue 4 June 2002
To view statistics on a T1 line or set a loopback on the line for diagnostic
purposes, enter the T1 command at the statistics prompt. For example:
(statistics)> T1
At the statistics:T1 prompt, enter the appropriate T1 interface command
option and the appropriate parameters from the following table to specify which
line to monitor, which privilege level you have, and the time period you want to
monitor.
Enter this ...and specify this
command ... parameter...
report network, secondary carrier, user
clearReport network, secondary
statusReport network, secondary
setLoopback network, secondary payload, line, AIS
clearLoopback network, secondary payload, line, AIS
usageReport hours [8]
...and this
...and this parameter time period
hour, day
[5]...20 min
363-208-050