Lucent Technologies SLC ConnectReach User & Service Manual page 473

Configuration Examples
Examples of the Different Methods of Configuring the
® ™
SLC ConnectReach System
LCR/DID Configuration Example
(Continued)
Configuration
setting example
(continued)
6. Go to the config/line menu. Set begin and end to the first and last FXS
ports used for phones. Set the signaling to match the line type of the
phones. Inspect the other parameters for accuracy. In most cases, they will
not need modification. Use the copy-to-channel-data command. This
configures the lines.
7. Go to the config/dialing menu. Use the show-all command to inspect the
system defaults. The default routes all direct dialed long distance and
international calls over the digital trunks; and all local, toll-free and
operator-assisted calls over the analog trunks. Refer to the following figure
for more detail.
8. If there are any seven-digit calls that are to be routed over the digital trunks
(seven-digit long distance call), enter the following commands:
detect-insert 6 4 AAA|BBB|CCC| |YYY
output-insert 4 1 - 1ZZZ
where AAA through YYY are the exchanges to be rerouted, and ZZZ is the
local area code to be prefixed to the digital trunk. Eliminate the "1" before
ZZZ if it is not required.
363-208-050
(Continued on next page)
B-15
Issue 4 June 2002