Lucent Technologies SLC ConnectReach User & Service Manual page 218

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Default Firewall
(Continued)
Procedure for
default IP filter plus
server firewall
4-132 Issue 4 June 2002
™
System
To configure the default IP filter plus server firewall, proceed as follows:
Step Procedure
1 At the Config prompt, enter the firewall command:
(config)>
firewall
The prompt changes to the Config:IPFirewall prompt.
(config:IPFirewall)>
2 At the Config:IPFirewall prompt, enter the default ipfilter plus
server command:
(config:IPFirewall)>
The prompt changes to the Change prompt.
Change Firewall config to the default 'only Outgoing
IPFilter and a server' settings?>[n]y: y
Enter 'y' to set the default IP filter plus server.
The prompt changes to the Config:IPFirewall prompt.
(config:IPFirewall)>
3 When you have made the necessary configuration changes, you can
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT).
NOTE:
The new command values take effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new values.
Stop! End of Procedure.
This completes the default firewall configurations. For the configuration settings
for each of these default commands, refer to the following section entitled Viewing
default firewall configuration settings on page 4-133.
default ipfilter server 207.104.144.1
(Continued on next page)
363-208-050