Lucent Technologies SLC ConnectReach User & Service Manual page 466

Configuration Examples
Examples of the Different Methods of Configuring the
® ™
SLC ConnectReach System
Customized Configuration Example
(Continued)
Example
B-8
Issue 4 June 2002
The following is an example of this type of configuration session on a system with
T1/DSX-1 interface. In this example, all commands are entered in their full form
for easier reading.
The example assumes that the site has been assigned a range of unique IP
addresses to be used on the Ethernet network. The simple network management
protocol (SNMP) host is a device on network 123.45.67.0, and access to the SLC
ConnectReach system is restricted to traffic from that network only. A secondary
permanent virtual circuit (PVC) is constructed, and a route to the access network
by means of the secondary PVC is declared. The secondary T1/DSX-1 interface
is connected to a private branch exchange (PBX) or key service unit (KSU) and is
DS0 voice channels and 12 DS0 data channels. In addition, the service provider
requires all WAN addresses to have a numbered interface.
******* System Image Boot *******
ConnectReach(tm) Access System(5.0.1 build 10)
Built: Jan 15 2002, 12:28:05
NVRAM version 0115
PB $Id: romInit.s,v 1.3 1997/03/07 01:37:26 dab Exp $
Copyright 1996 - 1999 VINA Technologies, Inc.
logged on as Carrier
> FRQI
(config)> 1HWZRUNW
(config:Network-t1)> HQDEOH RQ
(config:Network-t1)> IUDPLQJ (6)
(config:Network-t1)> OLQHFRGH %=6
(config:Network-t1)> FORFN QHWZRUN
(config:Network-t1)>
(config)> VHFRQGDU\W
(config:Secondary-t1)> HQDEOH RQ
(config:Secondary-t1)>
(config)> GV URYLVLRQLQJ
(config:DS0-provisioning)> DQDORJEHJLQ 
(config:DS0-provisioning)> DQDORJHQG 
(config:DS0-provisioning)> VHFYRLFHEHJLQ 
(config:DS0-provisioning)> VHFYRLFHHQG 
(config:DS0-provisioning)> GDWDEHJLQ 
(config:DS0-provisioning)> GDWDHQG 
363-208-050
(Continued on next page)