Lucent Technologies SLC ConnectReach User & Service Manual page 147

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Channel Bank Mode
(Continued)
Procedure (continued)
™
System
Step Procedure
10 Type exit or an exclamation point (!) (quoted as "\ |" through the
SLC-2000 Access System CIT) to return to the Config menu.
NOTE:
The new command values take effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new values.
Stop! End of Procedure.
363-208-050
Issue 4 June 2002 4-61