®
Configuring the SLC
ConnectReach
Using the Configuration Commands
Configuring Dialing (Continued)
Procedure
(continued)
4-96
Issue 4
June 2002
™
System
Step
Procedure
3
Use the show-all command to see the actual channel configuration.
4
Type exit or an exclamation point (!) (quoted as "\ |" through the SLC-
2000 Access System CIT).
NOTE: The new command values take effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new values.
Stop! End of Procedure.
363-208-050