Lucent Technologies SLC ConnectReach User & Service Manual page 167

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Lines (Continued)
BOX features
description
(continued)
™
System
For information on the user interface of the BOX features, refer to Appendix D,
"User Interface". The BOX features are described as follows:
NOTE:
Attendant consoles, busy lamp fields, digital phones, LCD displays are not
supported.
Distinctive-Ring
Transfer
Consultation-hold This command enables the consultation hold feature
Three-way calling This command enables the three-way calling feature.
This command allows incoming calls from an outside
trunk to be distinguished from local intercom calls. The
distinctive ring is a double ring (half second on, one
second off, half second on, four seconds off). A call
from an outside trunk transferred by an inside line is
rung as an outside call. Each line may be individually
configured to have distinctive ringing on or off.
This command enables the call transfer feature. Lines
may be configured independently of each other. It is
not possible to transfer a trunk to another trunk if both
trunks are loop-start. If there is a warm-start during the
transfer process, all connections are lost.
and may be set individually for each line. One, but not
both, of the parties may be connected from a
loop-start trunk. If there is a warm-start during a
consultation hold, all connections are lost.
This feature may be turned on or off for each individual
line. Consultation hold and transfer must be enabled to
activate three-way calling. One, but not both, of the
parties may be connected from a loop-start trunk. If
there is a warm-start during three-way calling, all
connections are lost.
363-208-050
(Continued on next page)
Issue 4 June 2002 4-81