About This Chapter; Introduction - Lucent Technologies SLC ConnectReach User & Service Manual

®
Provisioning the SLC -2000 RT/HDT

About This Chapter

About This Chapter

Introduction

Contents
6-2 Issue 4 June 2002
This chapter contains the following procedures that must be performed from a
®
SLC -2000 remote terminal/host digital terminal (RT/HDT) location before the
® ™
SLC ConnectReach
Configure the metallic distribution shelf (MDS) for fiber in the loop (FITL)
3
operation
Option and install the distant terminal (DT) Server in the metallic
3
distribution shelf (MDS)
Provision the DT Server
3
Establish cross-connections for each DS0 time slot in the network
3
T1/DSX-1 signal
Provision the SLC ConnectReach system channel units.
3
Since a craft interface terminal (CIT) will be used at the SLC-2000 RT/HDT to
perform most of these procedures, the information necessary to setup and
connect the CIT will also be included in this chapter.
Access System can be placed in-service:
363-208-050